Elite REALAXIOM B+ Bedienungsanleitung Seite 27

measure the power generated by the rider, but
the calculates it indirectly using mathematical
formulas.
Also, there are several variables not known by
the programme (for example: type of tyre, tyre
width, pressure between tyre and small rollers,
temperature, etc.), which have an affect on the
power generated by the system.
Per these two reasons, the accuracy of the value
displayed is variable and cannot be known priori.
However, it is possible to carry out a calibration
procedure with your own bicycle, if you have an
ergometer*. In being done with your own bicycle,
this procedure enables greater precision and
therefore a reduction in the power measurement
error.
For more information
procedure, consult on the Help (press F1) of the
programme in the section of the same name.
* instrument for measuring the power generated
by the rider when pedalling.
COPYRIGHT
No part of this manual may be reproduced or
transmitted without the written authorization of
Elite S.r.l.
Minimum System Requirements:
CPU:
OS:
PC Memory:
Hard disk:
Graphic Card:
Monitor resolution: 1024x768
Drivevers:
I/O Ports:
File System:
on the calibration
Pentium 4, 2.4GHz or equivalent
Microsoft Windows XP / Vista / 7 / 8
1 GB RAM
10 GB Free Space, 7200 RPM
256 MB of Memory
DVD-ROM Player (for use of RealVideo only)
1 Free USB port
NTFS or equivalent required
The Elite RealAxiom B+ software and relative
code are property of Elite S.r.l.
International copyright law protects the software.
The Elite RealAxiom B+ software must be treated
like any other copyrighted material, such as
books.
Users undertake not to modify or adapt the
programme. Users also undertake not to
decompile, disassemble
or attempt in any way to discover the native
software code.
NOTE
The presence of high-voltage electric lines,
traffic lights, electric railway lines, bus or tram
electric lines, television sets, automobiles, cycle
computers, gym equipment and mobile phones
inside the operating range of the console, etc., can
be the cause of interference. Therefore the use of
other wireless receivers may alter or completely
inhibit operation of the Wireless Console due to
such interference.
Do not expose the unit and the console to direct
sunlight for long periods when they are not in
use. Check the position and assembly conditions
of the frequency sensor and magnet at regular
intervals.
23