Elite REALAXIOM B+ Bedienungsanleitung Seite 33

- enable the heart-rate receiving in the
"Settings" menu;
- re-set the "Heart Device Number" from
"Settings -> Edit device trainer number"
menu, by checking the flag on the setting. Then
re-start the software;
- the batteries of the transmitter are charged;
- move away any radio devices that my interfere
as wireless devices, TV, mobile phones, etc...
REMOVING THE BICYCLE
To remove the bicycle, proceed as follows:
• Remove the console from the handlebar.
• Open the overtravel lever (RIF. Z) (Fig. 26).
• Disconnect the power supply to the roller, removing
the power adapter jack from the resistance unit.
• If installed, remove the cadence sensor from the
bicycle. Otherwise it is possible to also remove
the magnet from the pedal crank.
• Lift the stand locking lever with one hand (Fig.
17), while holding the bicycle saddle without the
other so that the bicycle does not fall over.
• Lift the bicycle and move it from the stand.
• The stand can then be closed so that it takes up
less space. In this case it is advisable to remove
all the cables and put them in a dry place together
with the console and USB key (Ref. 44).
• During long periods of inactivity and in case of
long travels, it is advisable to completely remove
the resistance unit from the trainer base and
store it in it's original packaging.
• Keep people, children and animals away from
the roller during use, since the moving and rota-
ting parts of the roller and the bicycle can cause
damage in case of contact.
• Before starting training, position the trainer
in a dry place, away from potentially hazardous
objects (furniture, tables, chairs, etc.) in order to
avoid any risk of inadvertent or accidental con-
tact with them.
• The resistance unit becomes warm when in use.
Wait until it has cooled before touching shells.
Whenever the roller has to be shipped for
assistance or for some other reason, special
attention must be paid to ensure its correct
packing.
• If it's connected, unplug the ground cable (Ref.
N) between unit and frame.
• Remove the resistance unit from stand, undoing
the 2 screws fixing it to the support plate.
• Unplug all cables from the resistance unit – ref.
Q; cadence sensor cable – Ref. H; ground cable
(ref. N) (if connected).
• Remove the USB key from the PC.
• Remove the cadence sensor from the bicycle
frame.
• Put the cables, cadence sensor, power adapter,
console and USB key inside a container in a dry
place.
• Pack the resistance unit in its original box. If
this box is not available, pack the unit, paying
particular attention to the flywheel. During
shipments, packs often undergo mistreatment
and very hard impacts, therefore inadequate
packing can result in permanent damage to the
roller. This type of damage is not covered by the
warranty. Pack the roller as though it had to be
dropped with box from a height of 1 metre.
Note: Before sending the roller or any other
component assistance, always firstly consult Elite
or the distributor.
ATTENTION
• Do not brake when using the trainer, as this can
permanently damage the roller and the tyre.
• The stand is designed for use by just one cyclist.
• Check the safety and stability of the bicycle be-
fore every training session.
• If the quick release is not compatible with the
bushings of the stand, replace it with the one
supplied (P).
• There are no individually usable components
PACKING
EN
29