cecotec Cumbia Power Espresso 20 Barista Aromax Bedienungsanleitung Seite 13

ENGLISH
5. CLEANING AND MAINTENANCE
• Disconnect the device from the power supply and allow it to cool down completely before
cleaning.
• Do not use abrasive cleaners or scouring pads as they could cause damage to the product's
surface.
• Use a soft, dampened cloth to clean the outer part of the device.
• Do not immerse the main body in water or other liquids.
• Wash the water tank, drip tray and cup-holder tray regularly.
• After using the steam function, the tube must be cleaned with a cloth immediately after.
Allow steam to be released to avoid possible blockages inside the tube.
• If the steam tube is clogged, use a needle to unblock the conduct.
• Turn the portafilter clockwise to detach it and empty all coffee residues inside it. Then,
use water and a cloth to clean it, do not wash the water tank, the coffee beans tank or the
portafilter holder in the dishwasher.
• Clean all parts with water and dry thoroughly before storing it or using the device again.
Cleaning mineral deposits
Mineral deposits built up in the unit might affect the machine's operating. It is important to
remove and clean them to keep the coffee machine operating efficiently. Quality of used water
and use will determine how often these deposits have to be cleaned.
It is recommended to carry out an Autocleaning cycle after each 1000 uses. If it is used 1000
working cycles, the machine will emit a reminder signal when turned on and the indicator lights
will blink in red twice.
1. Fill the water tank with water and descaling product up to the MAX. level. Citrus can also
be used.
Note: Water and descaling proportion is 4:1.
2. Press the On/off button, the machine will start preheating and the indicator light will turn
on steady.
3. Insert the portafilter in its position and make sure it is securely fitted.
4. Place a large container (approx. 2 L) on the cup-holder tray. Make sure it is big enough so
that water coming out from the water tube, nozzle and steam tube can fall inside it.
5. Press and hold the Hot water button for 5 seconds for the machine to enter Autocleaning
mode.
6. Turn the steam knob to the MAX. position. Hot water with descaling product (or the used
one) will be emitted through the portafilter spouts and hot water and steam tubes. This
process will take from 10 to 15 minutes, then the coffee machine will turn off.
24 POWER ESPRESSO 20 BARISTA AROMAX
7. Once it has finished, fill the water tank with clear water and repeat these steps until there
is no more descaling product.
8. Clean the water tank and the drip tray.
Notes:
– During the Autocleaning process, the pump will turn on and off intermittently, this is normal
and does not involve malfunction.
– During the Autocleaning process, the steam knob must not be set at "0". The machine will
beep once to remind it must be turned to the MAX. mark in order to clean the steam tube.
Cleaning the grinding unit
The mill is detachable and must be cleaned thoroughly.
To disassemble it, press the release button as shown, turn the adjustment knob to the maximum
setting, and then turn it in the disassembly direction shown in the figure to remove the mill
vertically.
To assemble it, align the mill with the slot on the unit and attach it vertically. Turn the adjustment
knob to the finest setting and turn the mill in the assembly direction until it clicks into position.
Each time the mill is used, the remaining coffee beans can be removed and the residual coffee
powder in the mill can be cleaned with the brush.
To clean the device properly, use a brush with semi-rigid bristles and remove coffee rests stuck
to the mill sides and to the base.
ENGLISH
POWER ESPRESSO 20 BARISTA AROMAX 25