Safety Instructions - HBM T22 Montageanleitung

4

Safety instructions

Designated use
The T22 torque transducer is used exclusively for torque measurement tasks,
and directly associated control and regulatory tasks. Use for any additional
purpose shall be deemed to be not as intended.
In the interests of safety, the transducer should only be operated as described
in the Operating Manual. It is also essential to comply with the legal and safety
requirements for the application concerned during use. The same applies to
the use of accessories.
The transducer is not a safety element within the meaning of its designated
use. Proper and safe operation of this transducer requires proper transporta-
tion, correct storage, assembly and mounting, and careful operation.
General dangers of failing to follow the safety instructions
The transducer corresponds to the state of the art and is failsafe. The
transducer can give rise to remaining dangers if it is inappropriately installed
and operated by untrained personnel.
Everyone involved with mounting, starting up, maintaining, or repairing the
transducer must have read and understood the Operating Manual and in par-
ticular the technical safety instructions.
Residual dangers
The scope of supply and performance of the transducer covers only a small
area of torque measurement technology. In addition, equipment planners,
installers and operators should plan, implement and respond to the safety
engineering considerations of torque measurement technology in such a way
as to minimize remaining dangers. On‐site regulations must be complied with
at all times. Reference must be made to remaining dangers connected with
torque measurement technology.
HBM
T22
A2302-6.0 en/de