Rs-232 Interface; Overview; Cable Connection - Schiller Argus VCM Gebrauchsanweisung

RS-232 Interface

Overview

Cable Connection

Nurse Call Interface
Overview Overview
ARGUS VCM ARGUS VCM
The 9-pin connector mounted on the rear panel provides an access port for a serial interface. The 9-pin connector mounted on the rear panel provides an access port for a serial interface.
RS-232 I/O port is intended only for connection to specified equipment in accordance with RS-232 I/O port is intended only for connection to specified equipment in accordance with
compliance requirements. compliance requirements.
Cable Connection Cable Connection
The Pin layouts (as viewed from the rear panel of
monitor provides RS-232 I/O port for software upgrade or nurse call system. monitor provides RS-232 I/O port for software upgrade or nurse call system.
Figure 46. RS-232 I/O connector
Figure 47. Data Port Pin Layout
Table 9. RS-232 Serial Interface Connections
Pin #
1
2
3
4
5
6
7
8
9
) are illustrated below.
ARGUS VCM
6 7 8 9
1 2 3 4 5
Signal
+5V (Use for Software Upgrade)
RxD_232 (RS-232 Input)
TxD_232 (RS-232 Output)
DTR (Use for Software Upgrade)
Signal ground (Isolated from Earth ground)
DSR (Use for Software Upgrade)
Nurse call A
Nurse call B
SMODE (Use for Software Upgrade)
Operator's Manual
ARGUS VCM
1
RS-232 I/O connector
71