Setting Pulse Tone Volume - Schiller Argus VCM Gebrauchsanweisung

Using the Monitor

Setting Pulse Tone Volume

This procedure will enable you to set Pulse Tone Volume of
With the monitor in the normal monitoring mode:
1. Press the Mode button 4 times until the Pulse Tone Volume setting indicator
2. Select a level of pulse tone volume between 0 and 8, using the Up/Down (+/-)
3. Press any other button to return to normal operation. If there is no activity for
30
ARGUS VCM
and current pulse tone volume are displayed.
selection buttons.
3 seconds, the monitor will return to normal operation.
Figure 13. Pulse Tone Volume Setting
Operator's Manual
ARGUS VCM
monitor.
ARGUS VCM