Printing Stored Patient Data (Optional Printer Installed); Erasing Patient Data - Schiller Argus VCM Gebrauchsanweisung

ARGUS VCM

Printing Stored Patient Data (Optional Printer Installed)

You can print vital-signs measurement data each time the monitor completes a
measurement cycle (stream printing), or you can store patient data and then print all of it at
one time (batch printing). For information on setting the printer for stream printing or batch
printing, see "Printing section" on page 67.
Follow the instructions to print stored data if an optional printer is installed.
1. Press Print button when the monitor is in Review mode to display stored data on the
screen.
Note: The print button is not enabled during an NIBP cycle.

Erasing Patient Data

All patient vital-signs data is stored even the monitor is powered off, however 24-hour old
data will be removed. You can also erase patient data when you change the time and date
settings and at any time during normal monitor operation.
Erasing Data During Normal Operation
To erase patient data during normal operation;
1. Press and hold the Review button for 3 seconds to erase data in the memory. After
data cleared, the monitor returns to normal operation.
If the monitor is not printing, press the Print button to start printing.
If the monitor is printing, press the Print button to stop printing.
Reviewing Patient Data
Operator's Manual
ARGUS VCM
65