Reviewing Patient Data; General; Displaying Stored Patient Data - Schiller Argus VCM Gebrauchsanweisung

Reviewing Patient Data

General

Displaying Stored Patient Data

Printing Stored Patient Data (Optional Printer Installed)
Erasing Patient Data
General
You can review stored patient data either by viewing it on the monitor or by printing it. The
monitor stores 200 measurement data. After 200 data is reached, the oldest stored data will
be deleted for the newest data. 24-hour old data will also be automatically deleted. Data is
recorded when patient measurement completes or an alarm condition occurs.
Pressing the Review button while the monitor is in Normal mode or Auto mode will enter
Review mode. This will cause the monitor to display the most recent data set. If SpO2 data
or temperature data is available when the NIBP cycle completes, that information will be
included in the record and will display in Review mode.
Displaying Stored Patient Data
1. Press the Review button to display the newest stored set of patient vital-signs data.
2. Press the Up/Down (+/-) selection button to cycle forward or backward (scroll)
through the stored measurement data sets. (The monitor stores 200 measurement
cycles.)
3. To stop reviewing data and return to normal operation, press any button other than
the Review button or the Up/Down (+/-) selection button.
The monitor interrupts the dynamic display of any current vital-sign
measurement.
The most current set of stored data including NIBP, SpO2, Pulse rate and
Temperature with a data-set sequence number and the time and date of the
displayed reading during a patient data review, if available, displays on entry
into Review mode.
The next most recent stored data sets display wrapping from the first stored
data set to the last by pressing the Review button subsequently.
In Review mode, the readings show time of reading in minus time, for
example, (-0:05) is 5 minutes ago, (-2:45) is 2 hour 45 minutes ago
Operator's Manual
ARGUS VCM
63