Resetting To Factory Defaults - Schiller Argus VCM Gebrauchsanweisung

Using the Monitor

Resetting to Factory Defaults

Following procedure will allow you to reset the monitor operating parameters to the
factory default settings.
With the monitor powered off:
1. Simultaneously press the Power button and the NIBP start/stop button.
2. The monitor runs a self-test and then displays the current monitor software
version.
3. Press the Mode button 4 times until " DEFAULT RESET=NO" is displayed.
4. To leave the settings unchanged, select 'NO' using only the Down (-) selection
button.
To reset the operating parameters to the factory default values, select 'YES'
using only the Up (+) selection button. The monitor immediately resets to the
defaults and the confirmation tone sounds.
5. To return to normal operation, turn the monitor off; then restart.
32
ARGUS VCM
Figure 15. Factory Defaults Setting
Operator's Manual
ARGUS VCM