Changing The Rinse Aid Dose - hanseatic HGVI6086B166901S Gebrauchsanleitung

page EN-14 Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover of rinse aid dispenser
(37).
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the rinse aid dispenser cover again.

Changing the rinse aid dose

We would recommend that you do not change
the dosage that was set by the factory initially.
(37)
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Open the appliance door.
2. Switch on the appliance with the
ton (1).
3. Press the
within 60 seconds of switching on the ap-
pliance.
4. Push the
mode for the rinse aid.
The indicator
rent value (
play (16).
5. Press the
desired dose is displayed (
= high).
d5
After approx. 5 seconds, the setting will
be stored.
To adjust the setting again, the appli-
ance must first be switched off again.
button (10) for 5 seconds
button (17) to switch to setting
(19) will flash. The cur-
to ) will flash on the dis-
d1 d5
button repeatedly until the
= low,
d1
but-