Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Water hardness in
your household in
°dH
0–5
6–11
12–17
18–22
23–34
35–55
1. Determine the relevant setting from the
table above.
2. Open the appliance door.
Adjusting the water hardness
Do not allow more than 60 seconds to elapse
between the following steps; otherwise, the
setting process will be interrupted.
1. Open the appliance door.
2. Switch on the appliance with the
ton (1).
3. Press the
button (10) for 5 seconds
within 60 seconds of switching on the ap-
pliance to access the selection menu for
setting the water hardness.
The indicator
(26) will flash.
4. Press the
button repeatedly until the
desired setting is displayed (16). The se-
quence is
to
H1
H6 .
After approx. 5 seconds, the setting will
be stored.
To adjust the setting again, the appli-
ance must first be switched off again.
Set-up, connection and initial start-up
Water hardness in
the dishwasher
H1
H2
H3
H4
H5
H6
but-
Automatic regeneration
In order to make sure that the water soften-
ing system works, the water softening sys-
tem is automatically regenerated at regular
intervals.
The regeneration process of your appliance
begins with the drying cycle. The water and
energy consumption then increases and
the duration of the programme is extended.
There is no regeneration process in the short
programme.
The frequency of the regeneration process
depends on the selected water hardness:
Regeneration process
°dH
Setting
0-5
H1
6–11
H2
12–17
H3
18–22
H4
23–34
H5
35–55
H6
Example ECO Programme: At a water hardness
level of
and under laboratory conditions, the
H3
programme runtime increases by 4 minutes. The
energy consumption increases by 0.02 kWh and
the water consumption by 2.0 litres.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
For the procedure, see chapter "Dishwasher
operation", from page EN-22.
page EN-35
all X programme
sequences
–
10
5
3
2
1
Werbung
Inhaltsverzeichnis
