Herunterladen Inhalt Inhalt Diese Seite drucken

Checking And Cleaning The Spraying Arms; Complete Cleaning; Protection Against Frost Damage - hanseatic HGVI6086B166901S Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3. Pull the fine filter out of the coarse filter.
4. Clean the filters carefully under running
water.
5. Put the filters back together and turn the
coarse filter in a clockwise direction up to
the stop point.
Checking and cleaning the
spraying arms
The nozzles in the spraying arm may calcify
or become dirty due to food scraps. Check
the nozzles regularly after each cycle and
clean them if required.
1. Empty both dish racks (32) and (33) and
remove the lower dish rack (33).
2. The upper spraying arm is affixed using
a bayonet closure. To remove the spray-
ing arm, hold the two serrated bayonet
grips (43) still and turn the spraying arm
clockwise.
Care and maintenance
3. Turn the lower spraying arm (34) upward
and outwards.
4. Clean the nozzles under running water.
5. Affix the spraying arm again after clean-
ing.
The spraying arm must be firmly affixed
and must be able to rotate freely.

Complete cleaning

In well-stocked supermarkets and drugstores,
you will find special dishwasher cleaning
products. Cleaning the appliance using these
products takes place when the dishwasher is
empty and is very intensive. You should clean
the dishwasher in this way regularly. When
doing so, please note the manufacturer's in-
structions on the packaging.
To prevent limescale deposits, please follow
the instructions for the correct setting of the
appliance (rinse aid and salt) (see "Dish-
washer detergents, rinse aids and dishwash-
er salts" on page EN-12).
Protection against frost
(43)
damage
Position the appliance in an area which is
protected from frost, if possible. If this is not
possible, protect the appliance against frost
as follows. You will need a shallow dish or a
pan, and a sponge.
1. Disconnect the mains plug from the sock-
et or switch off the fuse.
2. Close the tap and unscrew the inlet
hose (30).
3. Let the water from the inlet hose flow
completely into a dish.
4. Remove the filters (38).
5. Remove the water from the sump floor
with the help of a sponge.
6. Put the filters back in.
page EN-27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis