Changing The Rinse Aid Dose - hanseatic HGTI4582C10T7736ES Gebrauchsanleitung

Page EN-14 Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover of the rinse aid dispenser
(25).
2. Fill rinse aid up to the "max" mark into the
opening of the rinse aid dispenser.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the rinse aid dispenser cover again.

Changing the rinse aid dose

We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (18).
(5)
(13) (12)
2. Press the P button (13) for 5 seconds
within 60 seconds of switching on.
3. Push the plus button (12) to switch to set-
ting mode.
The indicator (5) will flash. The current
value ( to ) will illuminate on the dis-
d1 d5
play (10).
4. Press the P button repeatedly until the de-
sired dose is displayed (
5. Around 5 seconds after you push it for
the last time, the dishwasher will auto-
matically revert to the normal display.
The selected dose setting is saved.
= low, = high).
d1 d5