Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Set-up, connection and initial start-up
Choosing a suitable location
CAUTION
Risk of injury!
The appliance is heavy and bulky. Im-
proper handling of the appliance may
result in injury.
■ Seek the help of another person dur-
ing transport, installation and assem-
bly.
■ If a trolley is used to transport the ap-
pliance, the appliance must be moved
as shown on the packaging.
■ Only lift the appliance as shown on
the packaging.
■ Remove all obstacles on the transport
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the floor.
•
Set up the unit only in a dry and frost-
proof room with a solid base.
•
Position the appliance near a sink/wash
basin or floor drain for installation of the
connection pipes.
Having the outlet hose
connected
NOTICE
Malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
■ Make sure that the waste water can
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
■ Ensure that there are no kinks or dam-
age to the outlet hose.
Set-up, connection and initial start-up
■ Make sure that the end of the hose is
not submerged in the pumped water.
■ Do not extend the outlet hose or re-
place with another drainage pipe.
You can connect the end of the outlet hose (28)
in two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (si-
phon) of your washing/dishwashing ba-
sin. Technical measures are required for
this. For this reason, only plumbing ex-
perts or members of our service depart-
ment may connect the outlet hose (28)
(see page EN-40). The outlet hose must be
a maximum of 1000 mm above the floor.
page EN-29
Ø ≥ 40 mm
Werbung
Inhaltsverzeichnis
