Hart-Command 3 : Read All Dynamic Variables And Current; Hart-Command 6 : Write Polling Address - ABB Industrial IT enable FXT4000 COPA-XT Schnittstellenbeschreibung

3.4 HART-Command 3 : Read all dynamic Variables and Current

Request none
Data Bytes
Response #0..#3
Data Bytes
#5..#8
#10..#13
#14
#15..#18
#19
#20..#23
Response
Codes
Bemerkung

3.5 HART-Command 6 : Write Polling Address

Request
Data Bytes
Response
Data Bytes
Response
Codes
Analog Output Current mA, IEEE 754
#4 Primary Variable Unit Code (Table 2)
Primary Variable, IEEE 754
#9
Secondary Variable Unit Code (Table 2)
Secondary Variable, IEEE 754
Tertiary Variable Unit Code (Table 2)
Tertiary Variable, IEEE 754
4th Variable Unit Code (Table 2)
4th Variable, IEEE 754
0 No Command Specific Error
5 Incorrect Byte Count
Primary Variable =
Secondary Variable =
Tertiary Variable =
Fourth Variable =
#0 Polling Address of Device
#0 Polling Address of Device
0 No Command Specific Error
2 Invalid Selection
5 Incorrect Byte Count
Durchfluss, Einheit siehe unsigned char-Slot 3
Zähler >V, Einheit siehe unsigned char-Slot 4
Zähler <R, Einheit siehe unsigned char-Slot 4
Durchfluss, Einheit siehe unsigned char-Slot 3
Revision
Revision
9