Hart-Command 35 : Write Primary Variable Range Values; Hart-Command 38 : Reset Configuration Changed Flag; Hart-Command 40 : Enter/Exit Primary Variable Current Mode - ABB Industrial IT enable FXT4000 COPA-XT Schnittstellenbeschreibung

4.3 HART-Command 35 : Write Primary Variable Range Values

Request
Data Bytes #1..#4
#5..#8
Response
Data Bytes #1..#4
#5..#8
Response
Codes
Bemerkung

4.4 HART-Command 38 : Reset Configuration Changed Flag

Request none
Data Bytes
Response none
Data Bytes
Response
Codes

4.5 HART-Command 40 : Enter/Exit Primary Variable Current Mode

Request #0..#3 Fixed Primary Variable Current Level, IEEE 754, mA
Data Bytes
Response #0..#3 Actual Fixed Primary Variable Current Level, IEEE 754, mA
Data Bytes
Response
Codes
#0 PV Upper and Lower Range Values Units Code, Table II
Primary Variable Upper Range Value, IEEE 754
Primary Variable Lower Range Value, IEEE 754
#0 PV Upper and Lower Range Values Units Code, Table II
Primary Variable Upper Range Value, IEEE 754
Primary Variable Lower Range Value, IEEE 754
0 No Command Specific Error
2 Invalid Selection
5 Incorrect Byte Count
11 Upper Range Value too High
12 Upper Range Value too Low
13 Upper and Lower Range Values Out of Limits
PV Upper Range Value
PV lower Range Value
0 No Command Specific Error
5 Incorrect Byte Count
0 No Command Specific Error
3 Passed Parameter to Large (> 24.8 mA)
4 Passed Parameter to Small (< 3.85 mA)
5 Incorrect Byte Count
11 In Multidrop Mode
= Qmax
= 0
Revision
Revision
Revision
15