Usb/Memory Card Operation - Renkforce RF-RUDAB1805 Bedienungsanleitung

MOD/TA/
Button
• Keep this button pushed to switch the TA function on or off.
• When you receive a traffic programme station, the display shows TP (traffic programme).
• When you keep the TA button pushed, TA appears in the display as well.
• If a different audio source is being played back (USB playback for instance), the programme is set to mute during
the traffic announcement.
• When you listen to a radio programme at a very low volume, the volume is automatically increased to a pre-set
value.
• Additionally, this button is also used to operate the hands-free device (for more detail, see chapter "Bluetooth
operation" farther back in these instructions).
e) USB/Memory Card Operation
The device is equipped with a USB interface and a SD memory card reader. MP3 files stored on these media can
be played.
Do not connect any MP3-player to the USB interface if it is battery-operated. The USB interface power
supply may load the inserted batteries and cause overheating or explosion of a battery.
USB media up to 32 GB and a power intake of up to max. 500 mA can be connected to the USB interface.
SD cards up to 32 GB are supported as well. All media must be formatted in FAT 32.
Only USB storage media can be operated at the USB socket. MP3 players with a USB port usually switch
into PC mode when this port is connected. In this mode, music files cannot be played. However, you may
connect the audio output of your MP3 player to the AUX (17).
Due to the great variety of USB and SD storage media and their different functions, some of which are
very producer-specific, we cannot guarantee that all media will be recognized and that all the operational
functions are available on this device.
If the storage medium is not recognised, remove it and insert it again.
• Connect your USB storage medium with the USB port (6).
• If you use a SD memory card, insert it into the SD card reader (18).
• The player switches to the respective input automatically and starts playback.
• The last inserted medium is selected automatically each time.
Button 1/ (11)
• Push this button to interrupt the playback briefly.
• When you confirm the button again, playback will begin at the point where it was interrupted.
(3)
®
51