Monitor Relay Programming - Agilent Technologies Turbo-V 700 ICE Bedienungshandbuch

N
1
Where:
XX = indicates the rotational speed (40 KRPM for high speed, or
22 KRPM for low speed)

Monitor Relay Programming

The display shows:
H
S
Where:
XXKRPM = is the switch point of relay S1 at the preset turbopump
speed, adjustable from 00 to 42 KRPM.
The speed threshold will condition the S1 operation (see the
following cycle diagram] and it is factory-set to 40 KRPM.
The speed threshold will condition the S2 operation (see the
following cycle diagram] and it is factory-set to 22 KRPM.
Turbo-V 700 ICE Controller User Manual / 87-900-904-01 (L)
During acceleration of the pump or during any operating
condition, it is always possible to select the other parameters to
be displayed pressing the PUMP CURRENT or the CYCLE
NUMBER pushbuttons.
After the run up time and when the normal rotational speed is
reached, the display will be as follows, even if any previous
display selection was made, and the normal condition has been
reached.
O R M A
2 X X
. S .
E T T I
L O P E
K R P M
T H R E S
N G ; X
Technical Information
Use
R A T I
H J
H O L D
X K R P M
251/262
17
O N
H S