Warning Indicators; Technical Specification - Salter 9106 Bedienungsanleitung

WEIGHT & BODY FAT READINGS
Position the scale on a flat level surface.
1) Press the SET button.
2) Select your user number by pressing the L or M buttons.
3) WAIT while the display reconfirms your personal data then
shows a zero reading.
4) When zero is displayed,WITH BARE FEET, step onto the
platform and stand still. Ensure your feet are in good contact
with the 4 metal pads on the platform.
5) After 2-3 seconds, your weight will be displayed followed by
your body fat percentage, bone mass, total body water
percentage and muscle mass percentage.
Note:
When the body fat reading is displayed a horizontal bar will appear
above the body fat reading.This corresponds to the low, normal and
high printed above the display.This gives a general guide to your
body fat category - low, normal or high.Also refer to the normal
body fat tables on page 3.
Tip: Instead of steps 1 & 2 you can select your user number as follows:
Press and hold the platform with your foot. After 2 seconds the
user number will appear in the centre of the display and begin to
cycle. Release your foot when your user number is displayed.
6
Position the scale on a flat level surface.
Weight
Body Fat
BODY FAT
CATEGORY
a) Press the centre of
INDICATOR
Bone Mass
Body Water
Muscle Mass
WEIGHT READING ONLY
b) When '8888' appears,
the platform firmly to remove foot from
activate the scale. platform and WAIT
for display to show
a zero reading.

WARNING INDICATORS

'Lo' = replace battery.
'Err1' = overload.

TECHNICAL SPECIFICATION

100 cm - 220 cm
3'3" - 7'2"
16 - 80 years
Male/Female/Athlete
10 user memory
c) When zero is d) After 2-3 seconds,
displayed, step onto your weight will
the platform and be displayed.
stand still.
'Err2' = out of body
fat range or poor
feet contact.
d = 0.1 % body fat
d = 0.1 % body water
d = 0.1 % muscle mass
d = 0.1kg / 0.2lb bone mass
7