Commissioning; Unpacking; Belt Clip; Connecting The Telephone - AUDIOLINE CDL980G Bedienungsanleitung

AUDIOLINE CDL 980G

COMMISSIONING

UNPACKING

The following parts will be found in the package:
Handset
Base station
2 NiCd batteries
Operating instructions

BELT CLIP

If you want to carry your AUDIOLINE CDL 980G with you at all times, you can use
the fixing clip to fix the handset to your belt, for example.

CONNECTING THE TELEPHONE

Connect the telephone cable supplied to the telephone socket and the telephone
jack on the underside of the base station. The AUDIOLINE CDL 980G uses
Touch-Tone Dialling (TTD) and can be switched over to the older Pulse Dialling
system if necessary. More information is provided in the chapter on
"Programming".
Insert the power supply plug into the socket on the underside of the base station
and plug the power supply into a properly installed mains socket.
Open the battery compartment in the handset by sliding the cover of the battery
compartment away from the handset using light pressure on the lower end. Now
insert the batteries taking care to ensure that the polarity is correct. Close the
battery compartment.
Place the handset on the base station with the display to the top or to the bottom.
The charging light on the base station will come on.
Before being used for the first time, the handset must be charged continuously for
18 hours. When the handset is fully charged the charging light on the base station
flashes and the battery symbol
42
Belt clip
Power supply
Telephone cable
9V battery for the base station
appears in the display.
COMMISSIONING