Commissioning
3 Commissioning
Safety information
Before commissioning, it is essential that you read the
general information at the beginning of this manual.
Contents of pack
1 Telephone base
1 Telephone receiver
1 Telephone connection cable
1 Spiral cable
1 Operating Manual
Connecting the telephone receiver
After unpacking your telephone, you must first connect the
telephone receiver to the base unit. First take the short
end of the spiral cable and plug it into the socket at the
bottom of the receiver. Plug the long end of the spiral
cable into the lower socket on the rear side of the phone.
Feed the cable through the respective cable channel.
Connecting the telephone
Connect the telephone cable supplied to the telephone
socket and the upper jack on the rear side of the telepho-
ne (
). Feed the cable through the respective cable
channel.
The telephone works using the tone dialling system.
GB
17