Commissioning; Safety Information; Check Contents Of Pack; Connecting The Receiver - AUDIOLINE TEL7 Bedienungsanleitung

- Commissioning -

3 Commissioning
3.1

Safety Information

NOTE! Before commissioning, it is essential
that you read the general information at the
beginning of this manual.
3.2

Check contents of pack

The following items are supplied:
one telephone base
one telephone connection
cable
one operating manual
3.3

Connecting the receiver

After unpacking your telephone, you must first
connect the telephone receiver to the base
unit. To do this, take the short end of the spiral
cable and plug it into the socket at the bottom
of the receiver. Plug the long end into the
socket provided for the purpose on the
underside of the base unit and feed the cable
through the cable channel to the outside.
3.4

Connecting the telephone

Connect the telephone cable supplied to the
telephone socket and the telephone jack on the
underside of the telephone. Then feed the
cable out of the telephone housing either
upwards or downwards through the cable
guide. Clip the cable firmly in the cable
channel. The telephone works using the tone
dialling system (MFV).
3.5

Wall mounting

Your telephone is also suitable for wall
mounting. Use the two screws for fixing (not
included). Drill two holes 83 mm apart and
leave the screws protruding from the wall by
5mm. Now place the telephone over the screws
and push it slightly downwards. If you are
using the telephone fitted to the wall, you can
hang the receiver on the telephone without
hanging up. You will find a small hook for this
purpose above the receiver rest.
16
one telephone
receiver
one spiral cable