Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b) Programming additional functions
By default, the speed controller is preprogrammed with the optimal settings.
When using a LiPo vehicle battery, check the speed controller settings to confirm that undervoltage pro-
tection is enabled (normally 3.0 V/cell). If undervoltage detection is switched off, the LiPo battery may be
permanently damaged due to overdischarge.
When using a NiMH battery, disable undervoltage detection or configure a lower voltage setting.
The setup button can be used to program the settings.
Proceed as follows:
• Switch on the remote control and leave the throttle/brake lever in the
neutral position.
• Switch off the speed controller (move the switch to the "OFF" position).
• Hold down the setup button (B) next to the on/off switch (A) and turn
on the speed controller (move the switch to the "ON" position).
Keep holding down the setup button (B).
• The LED on the speed controller will flash red and the engine will beep
(keep holding down the setup button).
• The LED will start to flash green after a few seconds (keep holding down the setup button).
The number of green flashes (1x...5x) indicates the selected setting.
1x flash and 1x beep:
2x flashes and 2x beeps:
3x flashes and 3x beeps:
4x flashes and 4x beeps:
5x flashes and 5x beeps:
Beeps are generated by a brief activation of the brushless motor. This beep can be very quiet depending
on the engine. If this is the case, note the LED indication on the speed controller.
• Wait until the desired setting is indicated (e.g. undervoltage protection = three times green LED flashes and three
times engine beeps), and then release the setup button (refer to the next page for a table with the various setting
options).
• Now the LED flashes red again. The number of red flashing signals indicates which setting value is active (for
example, for undervoltage protection 3.0 V per cell, the LED flashes red four times briefly and the engine emits
four short beeps).
• Press the setup button to change the setting. The number of red LED flashes (and engine beeps) will change ac-
cordingly.
• Turn off the speed controller to exit settings mode and save the programming. If you then turn on the speed control-
ler, it will be ready for operation with the new settings.
• Follow the above steps to change the other settings.
50
Forward/reverse throttle or forward throttle only
Brake
Low voltage detection for the LiPo battery
Startup mode
Braking power
Werbung
Inhaltsverzeichnis
