Storage; Disposal; Service - Parkside PSG 85 A1 Originalbetriebsanleitung

If the max. rotational speed of the disc is
too low for the product, it could break!
Always use grinding discs in good condi-
tion (ringing test).
Do not widen the uptake bore in the grind-
ing disc if it is too small.
Do not use separate reducing bushings or
adapters to fit grinding discs if the bore is
too large.
Do not use saw blades.
Always completely reassemble the product
after replacing the grinding disc.
Switch off the product and
unplug from the mains. Allow the
product to cool down.
Loosen the 3 fastening screws
remove the grinding disc cover
Unscrew the grinding disc nuts
Remove the grinding disc
holder.
Place the new grinding disc on the uptake
and tighten the grinding disc nuts by hand.
Note: Make sure the grinding disc nut
is mounted as illustrated. The ribs of the
grinding disc nut should face outwards.
18b
Reinstall the grinding disc cover
Note: Do not over-tighten the grinding disc
nuts to prevent the grinding disc and nut
from breaking.
Perform a test run of at least 30 seconds
without load before using this product for
the first time and after changing the grind-
ing disc. Switch off the product immediately
if the grinding disc is out of round, consider-
able vibration occurs or you notice abnor-
mal noise.

Storage

Store the product in a dry location pro-
tected from dust, out of the reach of children.
Note: Grinding discs must be stored dry
and upright, never stack.
The packaging is made entirely of recyclable
materials, which you may dispose of at local re-
cycling facilities.
and
5
.
3
by hand.
18b
from the
18a
18b
.
3

Disposal

Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a)
and numbers (b) with following me-
aning: 1–7: plastics / 20–22: paper
and fibreboard / 80–98: composite
materials.
The product and packaging materi-
als are recyclable, dispose of it sepa-
rately for better waste treatment. The
Triman logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when
it has reached the end of its useful
life and not in the household waste.
Information on collection points and
their opening hours can be obtained
from your local authority.

Service

Have your product repaired at the service
centre or an electrician, using only original
manufacturer parts. This will maintain the
safety of this product.
Always have a plug or power cord replaced
by the product manufacturer or its service
centre. This will maintain the safety of this
product.
GB/CY 13