Suzuki AN400 2002 Serviceanleitung Seite 89

• Pull out the eight rollers 4.
• Remove the oil seals 5, 6.
ROLLER INSPECTION
• Check that there is no abnormal wear or damage on the roller.
Measure the diameter of roller with a vernier calipers. If the
outside diameter measured is less than the standard value,
replace the rollers as a set.
' Roller outside diameter:
Standard: 26.00 – 26.16 mm (1.02 – 1.03 in)
% 09900-20102: Vernier calipers
REASSEMBLY
• Reaseembly the movable drive face in the reverse order of
disassembly.
• Pay attention to the following points:
• Install the oil seal.
• Apply sufficient SUZUKI SUPER GREASE to the sliding sec-
tions of the movable drive face.
• Apply a small amount of SUZUKI SUPER GREASE to the
bore and oil seal lip.
" 99000-25010: SUZUKI SUPER GREASE "A" (Others)
99000-25030: SUZUKI SUPER GREASE "A" (USA)
$
* Replace the oil seal with a new one.
* Wipe off excess grease thoroughly.
• Position the eight rollers 1 on the movable drive face.
• Mount the three dampers 2 on the movable drive face plate
3.
• Position the movable drive plate on the movable drive face.
http://www.motorcycle.in.th
ENGINE 3-43