Self-Diagnostic Procedures; Self-Diagnosis Reset Procedure - Suzuki AN400 2002 Serviceanleitung

4-20 FI SYSTEM

SELF-DIAGNOSTIC PROCEDURES

• Don't disconnect couplers from ECM, battery cable from bat-
tery, ECM ground wire harness from engine or main fuse
before confirming malfunction code (self-diagnostic trouble
code) stored in memory. Such disconnection will erase mem-
orized information in ECM memory.
• Malfunction code stored in ECM memory can be checked by
the special tool.
• Before checking malfunction code, read SELF-DIAGNOSIS
FUNCTION "USER MODE and DEALER MODE" (#4-14,
15) carefully to have good understanding as to what functions
are available and how to use it.
• Be sure to read "PRECAUTIONS for Electrical Circuit Ser-
vice" (#4-2) before inspection and observe what is written
there.
• Remove the front leg shield cover.
• Connect the special tool to the dealer mode coupler A at the
wiring harness, and start the engine or crank the engine for
more than 4 seconds.
• Turn the special tool's switch ON and check the malfunction
code to determine the malfunction part.
! 09930-82720: Mode select switch

SELF-DIAGNOSIS RESET PROCEDURE

• After repairing the trouble, turn OFF the ignition switch and
turn ON again.
• If the malfunction code indicates (C00), the malfunction is
cleared.
• Disconnect the special tool from the dealer mode coupler.
http://www.motorcycle.in.th
ON OFF