Reassembly And Installation - Suzuki AN400 2002 Serviceanleitung

5-6 FUEL SYSTEM AND THROTTLE BODY

REASSEMBLY AND INSTALLATION

• Reassemble and installation the fuel tank in the reverse order
of removal and disassembly.
• Pay attention to the following points:
• Align the protrusion 1 of the fuel cut valve with the cutaway
2 of the gasket.
#
Replace the gasket with a new one.
• Install the fuel cut valve 3.
NOTE:
Install the fuel cut valve so that its hose fitting joint A faces the
right side of the vehicle.
• Tighten the fuel cut valve bolt to the specified torque.
% Fuel cut valve bolt: 3.5 N·m (0.35 kgf-m, 2.5 lb-ft)
• Apply thin coat of the engine oil to the O-ring 4.
• Install the O-ring to the fuel tank.
#
Replace the O-ring with a new one.
• When installing the fuel pump assembly, first tighten all the
fuel pump assembly mounting bolts lightly in the ascending
order of numbers, and then tighten them to the specified
torque in the above tightening order.
% Fuel pump mounting bolt: 4.5 N·m (0.45 kgf-m, 3.3 lb-ft)
• Install the FTPC valve.
#
Connect the hose to the black part A of the FTPC
valve.
http://www.motorcycle.in.th