Inhaltsverzeichnis
Werbung
8-34
ELECTRICAL SYSTEM
BATTERY
SPECIFICATIONS
Type designation
Capacity
a Anode plates
b Separator (fiberglass plate)
c Cathode plates
d Upper cover breather
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape 1 sealing the battery electrolyte
filler holes 2.
• Remove the caps 3.
NOTE:
* After filling the electrolyte completely, use the removed caps
3 as the sealed caps of battery filler holes.
* Do not remove or pierce the sealed areas 4 of the electrolyte
container.
• Insert the nozzles of the electrolyte container 5 into the bat-
tery's electrolyte filler holes, holding the container firmly so
that it does not fall. Take precaution not to allow any of the
fluid to spill.
• Make sure air bubbles 6 are coming up each electrolyte con-
tainer, and leave in this position for about more than 20 min-
utes.
FT12A-BS
12 V, 36 kC (10 Ah)/10 HR
e Stopper
f Filter
g Terminal
h Safety valve
http://www.motorcycle.in.th
Werbung
Inhaltsverzeichnis
Fehlerbehebung
