Device Description; Other Applicable Documents - Balluff BAV MA-NC-00028-05 Betriebsanleitung

BAV MA-NC-00028-05
Guided Changeover Solution

Device description

The Guided Changeover Solution consists of the Guided
Changeover Software and an Edge Gateway. The Guided
Changeover Solution enables safe, fast and partially
automated format changeover on plant and machinery
through intuitive and simple configuration of different
formats, creation and administration of work steps as well
as detailed operator guidance.
It provides support when setting lengths, widths and
heights (e.g. of the guide rails) and when replacing
interchangeable parts. The IO-Link components provide
immediate feedback as to whether the correct dimensions
have been set up.
Notes to the user
Validity
This guide describes the design, function and installation of
the Guided Changeover Solution and apply to the following
models:
– BAV MA-NC-00028-05
This guide is intended for qualified technical personnel.
Read this guide before installing and operating the Guided
Changeover Solution.
Always observe the warnings in this guide and the
measures described to avoid hazards.
Open Source Software
This product contains open source software. Information
can be found directly on the device at
http://<IP_EDGE_GATEWAY>/help?card=about.
Written offer
This product contains software components that are
licensed by the rights holders as Free Software or Open
Source Software under the GNU General Public License,
Version 2 or the GNU Lesser General Public License,
Version 2.1. You can obtain the source code of these
software components from Balluff GmbH on a data carrier
of our choice if you send a request to the following address
within three years after delivery of the product (delivery was
made by Balluff GmbH):
Balluff GmbH
Open Source
Schurwaldstraße 9
73765 Neuhausen a.d.F.
Please provide the following product data:
– Product name
– Serial number
– Delivery date
– Firmware version of the product
A fee will be charged that does not exceed the cost of
physically supplying the sources.
www.balluff.com

Other applicable documents

Additional information about this product can be found at
www.balluff.com on the product page, e.g. in the
following documents:
– Notes on the intended use of the Edge Gateway
– Configuration Guide
Safety
Intended use
The Guided Changeover Solution is designed to increase
efficiency and effectiveness when changing the format of
plant and machinery and is intended for use in the
industrial sector. The Edge Gateway is designed for
industrial use according to EN 61131-2 and IEC 61000-6-
2. The software can be operated with approved Balluff
sensors. Please see the product for further information.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the device or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
Reasonably foreseeable misuse
The product is not intended for the following applications
and areas and may not be used there:
– In safety-oriented applications in which personal safety
depends on the device function
– In explosive atmospheres
– In food applications
General safety notes
Installation and startup may only be performed by
qualified personnel having fundamental electrical
knowledge.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allows them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the device will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the device, take
it out of service and secure against unauthorized use.
To ensure long service life of the device observe the
following:
– Avoid exposure to dust, moisture and drastic
temperature changes.
– Do not drop the device and avoid strong vibration.
– Use a dry cloth for cleaning. Never use chemical
agents for cleaning.
english 1