Troubleshooting Guide - AEG Powertools PS 305 DG Originalbetriebsanleitung

MAINTENANCE
Infrequent Lubrication as Required
Apply automotive type oil directly on slide tubes. It will
■
be picked up and dispersed by built in felt wicks.
Apply a light oil or a pressurized light spray oil to the
■
arm pivot shaft (47).
Apply a light oil or a pressurized light spray oil to the
■
torsion spring (46) as shown.
Apply a light oil or a pressurized light spray oil to the
■
lower guard spacer (44), roller (45) and cover plate (3)
as shown.
MOTOR BELT TENSION (FIG. 26)
The motor belt tension was properly adjusted at the
factory. However, to check the belt tension:

TROUBLESHOOTING GUIDE

General
Problem Probable Cause
Blade hits table 1. Misalignment
Angle of cut not accurate 1. Misalignment
Can't move miter adjustment 1. Sawdust under table
Power head wobbles 1. Loose pivot points
Power head won't fully rise 1. Lubrication needed
or blade guard won't fully close 2. Part failure
3. Pivot spring or guard spring
not replaced properly after service
4. Sawdust sticking to stops
Blade binds, jams, burns wood 1. Improper operation
Rough cuts 2. Dull blade
3. Improper blade
4. Bent blade – check flatness
across expansion slots on blade
Tool vibrates or shakes 1. Sawblade not round
2. Sawblade damaged
3. Sawblade loose
4. Other
Power head hard to 1. Lube needed
pull/push down
16 ENGLISH
Use a Phillips screwdriver to remove the five screws
■
holding the belt cover and remove the cover.
To check the belt tension squeeze the belt. Using light
■
pressure the belt should deflect approximately
25.4 mm.
To adjust the tension:
■
- Use a Phillips screwdriver to loosen(but do not
remove) the six motormount screws.
- To increase the belt tension turn the adjusting
socket head set screw clockwise. To decrease the
tension turn the adjusting set screw counter-
clockwise.
Note: Excessive belt tension will cause the motor to
fail prematurely.
- Securely tighten the six motormount screws.
Replace the belt cover.
■
Suggested Corrective Action
1. Get authorized Service
1. See "Alignment" section
1. Vacuum or blow out dust
Wear Eye Protection
1. See Bevel Pivot Adjustment
in "Alignment" section
1. See "Lubrication" section
2. Get authorized Service
3. Get authorized Service
4. Inspect/clean stops
1. See "Basic Saw Operation" section
2. Replace or sharpen blade
3. Replace with 305mm diameter blade
designed for the material being cut
4. Replace blade
1. Replace blade
2. Replace blade
3. Tighten arbor screw
4. Get authorized Service
1. See - "Lubrication" section
ENGLISH 17