Hitachi P-GP160NAP Installations- Und Betriebshandbuch Seite 24

MOUNTING AIR INLET GRILLE
12.1 AIR INLET GRILLE MOUNTING DIRECTION (ONLY FOR P-GP160NAPU)
This Elevating Grille can be installed by any of 4 directions.
Please change the direction according to the customer's request.
12.1.1 When Installation Direction of Air Inlet
Grille is Not Changed (Factory Setting)
Check that the wire guide is attached to the "
air panel in the figure below, and then work according to Section
"12 Mounting Air Inlet Grille".
Factory setting
Wire guide mounting position
"○" Mark
12.1.2 When Changing Installation Direction of
Air Inlet Grille by 90 degrees
1 Remove the wire guides (4 places) from the air panel by
removing the screws (4 pcs.) that secure the wire guides
located at mark " " in the figure in Section
○
Inlet Grille".
2 Secure the wire guides to mark "
with screws.
Direction of air inlet grille
Factory setting
Changing by 90 degrees
Wire guide mounting position (after changing)
"□" Mark
"□" Mark
Secure with screws from the bottom of air panel
14 PMML0568 rev.0 - 01/2021
" mark on the
○
"○" Mark
Air panel
Wire guide
"12 Mounting Air
" located on the air panel
□
Position of wire guide
"○" mark on the air panel
Change to "□" mark on the air panel
Wire guide
Air panel
?
N O T E
• Ensure to tighten the wire guide with 0.8N.m torque.
• Excessive torque may lead to the wire guide damage.
3 Temporary Hanging of Suspension Wire
When opening or closing the electrical box cover of the
indoor unit, hang the suspension wire to the hook of the air
panel as shown below. After closing the electrical box cover,
make sure to remove the suspension wire from the hook.
Suspension
wire
Electrical box
Suspension
wire
Hook