Mounting Air Inlet Grille - Hitachi P-GP160NAP Installations- Und Betriebshandbuch

MOUNTING AIR INLET GRILLE

12 MOUNTING AIR INLET GRILLE

For P-GP160NAP and P-GP160KAP
1 With the air inlet grille tilted about 60 degrees with respect
to the air panel, hang the hook of the air inlet grille on the
projection part of the air panel.
2 Hook the safety chain of the air inlet grille into the hole on
the air panel (see part A below).
3 Close the air inlet grille.
4 The opening and closing direction of the air inlet grille can
be changed by 180 degrees. Please change the direction
according to the customer's request.
5 When changing the opening and closing direction of the air
inlet grille by 90 degrees, change the layout of the decorative
grille.
Air inlet grille
Safety chain
!
C A U T I O N
• Make sure to install the safety chain of the air inlet grille.
• Otherwise, the air inlet grille may be damaged and fall.

For P-GP160NAPU
!
C A U T I O N
Hold the air inlet grille securely for installation to prevent it from falling or
damage.
1 Remove the suspension wire from the cardboard around
which the suspension wire is wound.
2 Attach the wire holder suspended from the air panel to the
air inlet grille. (4 places)
13 PMML0568 rev.0 - 01/2021
60°
Projection part
A
Work by holding the center of
the air inlet grille firmly.
Attach the wire holder as
shown below
Wire holder
Air inlet grille
After inserting
Insert the wire holder with the position of
the rib of the wire holder as shown in the
figure above
Air inlet grille
Air panel
Suspension wire
Wire holder
Air inlet grille
Insert
After lock
Contact
After inserting the wire holder,
turn it clockwise until it clicks.