Attaching Decorative Grille - Hitachi P-GP160NAP Installations- Und Betriebshandbuch

ATTACHING DECORATIVE GRILLE

9 Attachment of corner pocket cover
a. Install the corner tether onto the hook as shown below.
Hook
Tether
Mounting tab
11 ATTACHING DECORATIVE GRILLE
1 Hook the tabs (Ⓐ 4 places and Ⓑ 2 places) of the
decorative grille on the air panel.
2 While pressing the decorative grille against the bottom
surface of the air panel, slide the tabs Ⓐ in the direction of
the arrow so that they enter the slits on the air panel, and
hook the tabs (6 places).
3 Push in the decorative grille until it clicks.
?
N O T E
• Only for P-GP160NAPU: The decorative grille can be installed by
any of 4 directions. Please change the direction according to the
customer's request.
• Make sure that the projection part of knobs on both ends of the
decorative grille are securely hooked on the tabs on the air panel as
shown below. Otherwise, the decorative grille and the air inlet grille
may fall and cause injury.
Tab of air panel
Projection
part of knob
12 PMML0568 rev.0 - 01/2021
Ⓐ
Mounting tab
Mounting tab
Ⓑ
!
C A U T I O N
Securely attach the tether to the hook. Failure to secure the corner cover
can cause it to drop to the floor with possible injury to those nearby or
damage to the cover.
b. As shown in the figure, insert the mounting tab A
(1 place) into the screw, and insert the mounting tabs
B (3 places) so that they hook onto the outer periphery of
the air panel. After attaching, tighten the screw.
Ⓑ
B
A
Knob
Ⓑ
Tab
Ⓐ
Tab
Slits
Ⓐ
Tab
B
Screw
B
Decorative grille (2 portions)
Ⓐ
Tab
Tab
Knob
Ⓑ