Hitachi P-GP160NAP Installations- Und Betriebshandbuch Seite 18

MAINTENANCE
4 Attach the air inlet grille.
Attach the air inlet grille in the reverse procedure to
removing.
!
C A U T I O N
• Make sure to install the safety chain of the air inlet grille.
• Otherwise, the air inlet grille may be damaged and fall.

In the case of P-GP160NAPU
!
C A U T I O N
• Make sure to follow the operation manual when elevating the air inlet
grille and attaching and removing the air filter. The air filter or the air
inlet grille may fall and cause injury.
• Remove the air inlet grille from the suspension wire before cleaning
the air inlet grille. Otherwise, the air inlet grille may fall and cause
injury.
1 The air panel with air inlet grille lowers the air inlet grille.
2 Remove the wire holders (4 portions).
Remove the wire holder from
the air inlet grille by twisting it
counterclockwise as shown below.
Wire holders (4
portions)
Work by holding the center of the
air inlet grille firmly.
8 PMML0568 rev.0 - 01/2021
Air inlet grille
Twist counterclockwise
Air inlet grille
3 Clean the air inlet grille.
4 Attach the air inlet grille.
When the air inlet grille is dry, attach the air inlet grille by
reversing the removal procedure.
When attaching, align the decorative grille and air inlet grille
in the same direction.
Air panel
Suspension wire
Wire holder
Attach the wire holder as shown below
Wire holder
Air inlet grille
After inserting
Insert the wire holder with the position of
the rib of the wire holder as shown in the
figure above
Decorative grille
Air inlet grille
Insert
After lock
Contact
After inserting the wire holder,
turn it clockwise until it clicks.