Scheppach 5905112902 Originalbetriebsanleitung Seite 24

• Refit all guards and safety devices immediately af-
ter you have completed any repairs or maintenance
work.
• Be sure to observe the safety information and op-
erating and maintenance instructions issued by the
manufacturer, as well as the dimensions listed in
the Technical Data.
• It is imperative to observe the accident prevention
regulations in force in your area as well as all other
generally recognized rules of safety.
• Note the information published by your professional
associations (VBG 7j).
• The circular saw has to be connected to a 400 V
socket with a 16 A fuse.
• Do not use any low-powered machines for heavy
duty work.
• Do not use the cable for purposes for which it is
not designed.
• Make sure you stand squarely and keep your bal-
ance at all times.
• Check the tool for damage.
• Each time before re-using the tool, carefully check
that the guards or any slightly damaged parts are
working as intended.
• Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted cor-
rectly and that all other operating conditions are
properly fulfilled.
• Unless otherwise stated in the operating instruc-
tions, damaged safety devices and parts must be re-
paired or replaced by an authorized service center.
• Have damaged switches replaced by a customer
service workshop.
• This electric tool complies with the pertinent safety
regulations. Repairs are to be carried out only by a
qualified electrician using original replacement parts
or the user may suffer an accident.
• If necessary, wear suitable personal protection
equipment. This could consist of:
• Ear plugs to prevent the risk of damaging your
hearing;
• A breathing mask to avoid the risk of inhaling haz-
ardous dust.
• Always wear gloves when handling saw blades and
rough materials. Whenever practicable, saw blades
must be carried in a container.
• The operator must be informed about the conditions
that influence the generation of noise (for example
saw blades designed to reduce noise emissions,
caring for blades and the machine).
24 | GB
• Faults on the machine or its guards, safety devices
and blade must be reported to the person in charge
as soon as they are discovered.
• Use only the transport devices to move the machine.
Never use the guards for handling and moving the
machine.
• All operators must receive proper training in the use,
adjustment and operation of the machine.
• Do not saw any materials that contain foreign bodies
such as wires, cables or ties.
• Only use sharp saw blades
• The machine must stand during the operation on a
horizontal , flat floor and the floor around the ma-
chine must be level, well maintained and free of
debris, such as Be chips and cut workpieces.
• Adequate general lighting or local lighting must be
available.
• Assign the workpiece to be machined and the stack
finished workpieces close to the normal work of the
operator.
• Make it adopt the safe procedures for cleaning,
maintenance and the regular removal of chips and
dust to avoid the risk of fire.
• Follow the instructions of the manufacturer for use
, adjustment and repair of saw blades.
• Note appearing on the blades maximum speed.
• Make sure that the flanges used are as specified
by the manufacturer , suitable for the intended use.
• Make sure you include that necessary for operat-
ing the machine guards and other safety devices
are fitted, they are in good operating condition and
properly maintained.
• The dust level is influenced by the type of material
to be cut.
Warning! This electric tool generates an electromag-
netic field during operation. This field can impair active
or passive medical implants under certain conditions.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the electric tool.
www.scheppach.com