Transport; Storage; Disposal And Recycling - Scheppach 5905112902 Originalbetriebsanleitung

Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Saw blade, Rocker inlet
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
Change of saw blades (fig. 11 - 15 )
m Remove the mains plug before changing the saw
blade.
m Danger of cutting! The saw blade is massive and it
could be to slick.
Wear gloves when replacing the saw blade.
• Do not use any saw blades made of HSS steel.
• Do not use any cracked saw blades or such that
have changed their shape.
• Only use well-sharpened saw blades.
m Danger of burning! The saw blade is still hot shortly
after cutting.
1. Firmly hold the tilt table pull out the spring cotter
pin (fig. 11, A).
2. Loosen the hexagonal nut (fig. 12 B), firmly hold
the tilt table and pull the swivel's guide rail (fig. 12
C) from the threaded pin (fig. 12 D).
3. Slowly lower the tilt table towards the ground.
4. Use the locking pin (fig. 13, 14) to secure the saw
blade against turning.
5. Loosen the screw (fig. 14, E).
6. Remove the washer (fig. 14, F), the front saw
blade flange (fig. 14, G) and the saw blade (fig.
14, H).
7. Clean the saw blade flanges
8. Install a new or sharpened saw blade.
Pay attention to the correct running direction of
the saw blade: The arrow on the safety guard and
the arrow on the saw blade must show to the same
direction.
9. Reinstall the front saw blade flange and the wash-
er
10. Secure the saw blade using the screw.
11. Slide the both washers on the support pin (fig.
15, I).
28 | GB
12. Lift the tilt table and guide the support pin into the
hole (fig. 15, J).
13. Insert the swivel's guide rail (fig. 12, C) to the
threaded pin (fig. 12, D) and fix it with the hexag-
onal nut (fig. 12, B)
14. Plug the spring cotter pins (fig. 11, A) through the
support pin (fig. 15, I).
15. Remove the locking pin (fig. 13, 14).
Replacing the plastics insert
Immediately replace the worn or damaged plastics
inserts (fig. 1, 11).
1. Loosen the screws of the plastics insert and re-
move them.
2. Insert a new plastic insert and screw it tightly in
place.

13. Transport

Transport fig. 9
Place the jack in the transport position and secure it
with the locking lever (18) fig. 2
Hold the handle, put one foot onto the axle and tilt the
machine towards your body
In this position it is easy to move the machine.
Attention! The saw may only be used when all four
feet are securely on the ground.

14. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing tem-
perature. The ideal storage temperature is between 5
and 30 °C. Store the electric tool in its original pack-
aging.

15. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories
are made of various types of material, such as
metal and plastic. Defective components must
be disposed of as special waste. Ask your dealer or
your local council.
www.scheppach.com