Risks Due To Accessories; Safety Measures At The Installation Site; Safety Devices - Behncke Europa 1002 Betriebsanleitung

2.4 Risks due to accessories

Only accessories from BEHNCKE
Accessories must not endanger the safety of the system.

2.5 Safety measures at the installation site

The filter system must be stably mounted on a flat and solid surface or on a mounting plate.
Make sure that the maximum operating pressure of 2.0 bar and operating temperature of 40°C are
not exceeded.
Only run the system if all the safety devices are fully functional.
The system and its surroundings may be damaged.
There must be a sufficiently large floor drain in the installation room to avoid water damage if there
are any leaks.

2.6 Safety devices

The warning signs on the pump indicate the risks due to electric current.
Filter tank stainless steel / General information and safety information
DANGER
The electrical equipment in the system is under high voltage.
As a result, please observe the following instructions:
• Work may only be carried out on the electrical equipment by electricians.
• The electrical equipment in the system must be inspected regularly.
• Loose connections and damaged components must be secured
or replaced immediately.
Disconnect the system from the mains before carrying out maintenance work!
There is a risk of injury and damage to the system.
Never remove safety devices or put them out of operation by modifying
the system!
®
may be used.
DANGER
Check the system for leaks, externally-visible damage and functionality at least
once a week while the pool is running.
5