Product-Related Information - Behncke Europa 1002 Betriebsanleitung

2.1 Product-related information

The filter system is only designed for circulating and filtering swimming pool water in private pools in
rooms which are not potentially explosive.
Any other use or use that goes beyond this is considered improper use.
The manufacturer BEHNCKE
If another purpose is intended, this must be confirmed by BEHNCKE GmbH
Filter tank stainless steel / General information and safety information
®
is not liable for any damage resulting from this.
NOTE
Proper use also includes
• observing all the instructions in the instruction manuals
• complying with inspection and maintenance works
NOTE
The maximum permissible operating pressure of 2.0 bar,
and the maximum operating temperature of 40°C must not be exceeded!
NOTE
Danger from misuse!
Only use original replacement parts.
Modifications and alterations to the system components are forbidden for
safety reasons.
For safety reasons, modifications and alterations to the pipelines and the
electrical installation may only be carried out by qualified personnel.
NOTE
The filter tank is to be incorporated into Article 4(3) of the Pressure Equipment
Directive 2014/68/EU and may, as a result, not bear a CE mark.
According to the guideline for Directive 2014/68/EU
• B-08 tank, with water under 100°C
This type of tank is classified in accordance with DGR table 4 (diagram 4).
The operator is obliged to install a manual vent or a continuous vent at the
top of the tank (opening available)!
ELECTRICAL CONNECTION
The filter tank must be connected to additional protection potential
equalisation if there is an electrically conductive connection to electrical
equipment.
This may be the case, for example, if the filter tank is connected to the filter
pump or other electrical equipment by means of electrically conductive pipes
(e.g. stainless steel pipes).
With regard to electrical installations in swimming pools, please observe
DIN VDE 0100 part 702.
®
in writing!
3