Before Initial Use; Unpacking The Items Supplied; Charging Up The Battery; Use - Cleanmaxx Z 04851 - 7001-INT-2 RoboMop Softbase Gebrauchsanleitung

Before Initial Use

Before you can use this device, you must:
• unpack the items supplied,
• charge up the battery.

Unpacking the Items Supplied

PLEASE NOTE!
❐ Keep children and animals away from the packaging material. There is a danger of
suffocation!
Unpack all parts and check the scope of supply for completeness (see the "Scope of Supply
and Device Overview" chapter) and transport damage. If you fi nd any damage to the compo-
nents, do not use them (!), but contact our Customer Service department (see the "Customer
Service" chapter).

Charging Up the Battery

PLEASE NOTE!
❐ Only charge up the device once the battery is completely empty.
It takes approx. 3-5 hours for an empty battery to fully charge up.
1. Insert the plug of the mains cable into the connecting socket of the robot ball.
2. Insert the mains adapter into a properly installed mains socket that is easily accessible.
After that, the charging procedure begins. A battery symbol will fl ash on the display.
3. Once the battery is fully charged up, the battery symbol stops fl ashing and is shown per-
manently on the display. Disconnect the device from the mains power. The device is now
ready for use!

Use

Preparing the Room

• Remove any objects from the fl oor that may get caught in the mop frame or prevent the
device from cleaning. In particular, do not leave plastic bags on the fl oor.
• Make sure that no cables, cords or fringes, for example from curtains, tablecloths or rugs,
are accessible to the device.
• Remove all objects that could be tipped over (e. g. vases, small lamps, decorations).
• The distance between two objects (e. g. a wall and a piece of furniture) must be at least
30 cm so that the device can get through. The device requires approx. 10 cm of space
above it so that it does not get stuck under a piece of furniture.
16