Safety Instructions - LUND 67882 Originalanleitung

EN
MACHINE SPECIFICATION
Vacuum packaging machine is designed for vacuum packaging of food products in the special bags which are the intended for it.
Thanks to this packing the food keeps longer its freshness and nutritional value. The product has been designed exclusively for
domestic use and is not designed for use in commercial applications.
ATTENTION! The machine should be used only with plastic bags which are specifi cally designed for vacuum packaging
machines. It is forbidden to use regular plastic bags or other bags which are not designed for vacuum packaging machines.
ATTENTION! Food packaging bags you should use the bags which are intended to come into contact with food.
Correct, reliable, and safe operation of the tool is dependent on its proper use, therefore:
Prior to working with the product, you should read all the instruction and keep it around.
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not responsible.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. The product is not supplied with the bags.

SAFETY INSTRUCTIONS

ATTENTION! Read all the instructions below. Failure to comply with them can lead to elec-
trical shock, fi re or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the device in an environment of increased risk of explosion, which is containing
fl ammable liquids, gases, or vapours. Set the device on a fl at, even and hard surface. When
selecting the place for placement, consider the space needed for a bag. The bag may not
hang out from the packaging machine, it should lie on the same ground as packaging ma-
chine. Otherwise, the bag may be slip out from the handle of welding device. Do not place
the device near sources of heat or fi re. Packaging machine has the ability to roll in the power
cable to the slot on the bottom or on back of the housing. Before each use you should com-
pletely unroll the power cable. Connect the unit only to the mains of voltage and frequency
shown on the rating plate of the device. Power cable plug must fi t into the wall outlet. It is
forbidden to modify the plug. Do not use any adapters in order to adapt the plug to the outlet.
The unmodifi ed plug, which fi ts the outlet, reduces the risk of electric shock. After each use,
you should disconnect the power cable plug from a mains outlet. Avoid contact with earthed
surfaces such as pipes, radiators and refrigerators. The earthing of body increases the risk
of electric shock.The device designed for indoors operation only. Do not expose the device
to humidity or precipitation. Water and moisture that gets inside the device, it increases the
risk of electric shock. Do not immerse the device in water or any other liquid. Do not overload
power cable. It is forbiddent to use the power cable to carry out, connect and disconnect
the plug from wall outlet. Avoid contact of the supply cable with heat, oil, sharp edges and
moving parts. Damaged cable increases the risk of an electric shock. In the event of damage
to the power cable (for example, the cutting, melting of insulation), you should immediately
disconnect the plug from the wall outlet, and then pass the product to the authorized repairing
service. It is forbidden to use the device with a damaged hose. It is prohibited to repair the
power cable, the cable must be replaced with a new one at the authorized service point. In
the case of the use of extension cables, extension cables should be used with such power
supply parameters as these shown on the nameplate of the appliance. Cross section of the
extension cable wires should be not smaller than the cross section of the wires of device
O R I G I N A L I N S T R U C T I O N S
11