Configuring A Kvm-Over-Ip Connection - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Establishing a KVM-over-IP™ connection for the first time
3. Select the entry
4. Select the entry
5. Enter the following data under
Global
preferences:
Hostname:
Domain:
Gateway:
DNS Server 1:
DNS Server 2:
6. Press to save your settings.
F2

Configuring a KVM-over-IP connection

The IP address of the console module (host) as well as the
module must be specified to establish a
puter module.
The configuration of both the
exchanged between the two modules.
NOTE: The configuration of both the
automatically exchanged between the two modules.
How to configure the ports of the KVM-over-IP connection:
1. Use the local hotkey
2. Press to open the Configuration menu.
F11
3. Select the entry
IMPORTANT:
In order to protect the configuration of the KVM-over-IP connection
from unwanted access, we recommend to activate the password protection.
Select the
Password protection
4. Enter the following data under
Control Port:
Communication Port:
Data Port:
5. Press F2 to save your settings.
31 · G&D VisionXS-IP-C-DP-UHR
Network setup and press
and press
Interfaces
Main Network
Press F8 to select the global preferences:
uses static settings.
 Static:
 DHCP: obtains settings from a DHCP server.
Enter the device hostname.
Enter the domain the device is to belong to.
Enter the gateway IP address.
Enter the IP address of the DNS server.
Optionally, enter the IP address of another DNS server.
communication ports
Alt + Num to open the OSD of the console module.
KVM Connection and press
entry, press
Local
Enter the number of the port you want to use.
Enter the number of the port you want to use.
Enter the number of the port you want to use.
Enter .
.
Enter
:
KVM-over-IP connection through the com-
and the
communication ports
Enter .
( ) and then
F8 on
:
control port of the computer
are automatically
data ports
and the
data ports
to save your settings.
F2
are