Configuring The Network Interface - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Configuring the network interface

How to configure the network interface:
1. Use the local hotkey
work interface of the console module or use the
open the remote OSD to configure the network interface of the computer module.
2. Select the entry Network setup
3. Select the entry Interfaces
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press F2 to save your settings.
(default: Alt + Num ) to open the local OSD to configure the net-
and press Enter
and press Enter .
Interface A :
Press F8 to select the operational mode of the interface:
 Off: switch network interface off.
 Static: A static IP address is assigned.
IP address is obtained from a DHCP server.
 DHCP:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
Initial configuration of the network settings
remote hotkey (default:
.
G&D VisionXS-IP-C-DP-UHR · 20
Ctrl + Num ) to