Changing Your Password; Selecting The Language - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Changing your password

IMPORTANT: The OpenAccess operating mode is set by default. In this operating
mode, access to the KVM extender is not protected by authentication. Information
on the operating modes can be found in chapter Operating modes of console modules
on page 70 ff.
How to change the password of you user account:
1. Press Ctrl+Num
2. Press to open the
F10
3. Select the Change password entry and press
4. Enter the new password into the Change own password menu:
New  Enter your new password.
 Repeat your new password.
Repeat
5. Press to save your settings.
F2

Selecting the language

The specified system language is assigned to all user accounts by default. If required,
you can permanently assign a (different) language to each user account.
NOTE:
All language settings apply to both the web application and the OSD of the
device.
If the OSD does not support the selected language, the OSD will be displayed in
English.
How to set the language:
1. Press Ctrl+Num
2. Press F10 to open the
3. Under
Language
from system Use the system language
[Selection]  Use the selected language
4. Press F2 to save your settings.
(default) to open the OSD.
menu.
Personal Profile
(default) to open the OSD.
Personal Profile menu.
press to choose between the following options:
F8
Configuration
Enter .
G&D VisionXS-IP-C-DP-UHR · 72