Herunterladen Inhalt Inhalt Diese Seite drucken

Link Aggregation - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Vorschau ausblenden Andere Handbücher für VisionXS-IP-C-DP-UHR:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Initial configuration of the network settings

Link aggregation

IMPORTANT:
To increase reliability, you can enable the
the KVM extender with the
Both interfaces are combined into a group via link aggregation. Within a group, only
one interface is active at a time. Another interface only becomes active if the active
interface fails.
Two different modes are available for monitoring the interfaces:
The carrier status of the network interface is monitored via the media
 MII mode:
independent interface überwacht. In this mode, only the functionality of the network is
tested.
 ARP mode:
Using the address resolution protocol, requests are sent to an ARP target on
the network. The response from the ARP target confirms both the functionality of
the network interface and a proper network connection to the ARP target.
If the ARP target is connected to the network but temporarily offline, the requests
cannot be answered. For this reason, you should determine several ARP targets in
order to obtain a response from at least one target even if an ARP target fails.
NOTE:
It is not possible to combine
How to configure the settings of grouped network interfaces:
NOTE:
The Link Local address space 169.254.0.0/16 is reserved for internal com-
munication between devices in accordance with RFC 3330. It is not possible to
assign an IP address of this address space.
1. Open the remote OSD of the computer module by pressing the
(default:
Ctrl+Num
module.
Open the local OSD of the console module by pressing the
), if you want to change the configuration of the console module.
Alt+Num
2. Select the row
Network setup
and press
work
Enter
3. Select the row
Link aggregation
23 · G&D VisionXS-IP-C-DP-UHR
Transm. Redundancy
MII
), if you want to change the configuration of the computer
and press
(local OSD).
and press
Transmission 2
feature, which is available for a fee.
and
ARP mode
.
Enter
(remote OSD) or
Enter
.
interface of
remote hotkey
(default:
local hotkey
F11
, select the row
Net-

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis