Configuring A Kvm-Over-Ip Connection Of A Console Module; Configuring The Network Interface; Configuring The Global Network Settings - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Configuring a KVM-over-IP connection of a console
module
You can carry out the required configuration settings directly on the console.
NOTE: Use the local hotkey
the network interface of the console module, or use the
+ ) to open the remote OSD to configure the network interface of the com-
Ctrl Num
puter module.
The settings of both hotkeys are shown during the starting process of the console
module (see Starting process on page 17).

Configuring the network interface

How to configure the network interface:
1. Use the local hotkey
2. Press to open the Configuration menu.
F11
3. Select the entry Network setup
4. Select the entry Interfaces
5. Enter the following data under
Operational
mode:
IP address:
Netmask:
6. Press to save your settings.
F2

Configuring the global network settings

Even in complex networks global network settings ensure that the KVM extender is
available from all partial networks.
How to configure global network settings:
1. Use the local hotkey
2. Press to open the Configuration menu.
F11
Establishing a KVM-over-IP™ connection for the first time
(default: Alt + Num
+ to open the OSD of console module.
Alt Num
and press Enter
and press Enter .
Transmission
Press F8 to select the operational mode of the interface:
A static IP address is assigned.
 Static:
 DHCP: IP address is obtained from a DHCP server.
switches off network interface.
 Off:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
+ to open the OSD of the console module.
Alt Num
) to open the local OSD to configure
remote hotkey
.
:
G&D VisionXS-IP-C-DP-UHR · 30
(default: