Further information
Determining network settings via service port
If you do not know the IP address of an already configured user or computer mod-
ule, you can use the service port of the module to find out the address.
Use any terminal emulator (e.g. Tera Term or PuTTY) to show the log messages of
the modules.
Installing the device driver
Before establishing a connection using the terminal emulator, install the device
driver
CP210x USB to UART Bridge VCP
NOTE:
When connected to a service cable, the driver provides the Service port of a
user or a computer module as a virtual serial interface (COM port). The virtual
interface can then be selected to establish a connection using the terminal emula-
tor.
How to install the device driver to address the service port:
1. Use any web browser to open the website
2. Go to
More from G&D > Tools & Driver
3. Download the device driver for the operating system installed on the computetr.
4. Execute the file and follow the instructions of the installation wizard.
Establishing a connection by using a terminal emulator
How to establish a connection using a terminal emulator:
1. Start any terminal emulator (e.g.Tera Term oder PuTTY).
2. Establish a new connection via terminal emulator and enter the follwoing set-
tings:
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control:
3. Use the supplied USB service cable to connect the computer to the Service port on
the front panel of the user or computer module.
95 · G&D VisionXS-IP-C-DP-UHR
.
.
115.200
8
None
1
None
www.gdsys.com/en/start
.