Installing The Computer Module - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Installing the computer module

NOTE: All device variants of the
power supply at the Power
The illustrations in this chapter show the DT variant of the device series. This
variant is additionally equipped with an internal power supply (
The computer, whose signals are transmitted to the remote console, is connected to
the computer module.
VisionXS-IP-CPU
Establishing a connection to a local management network
Transmission 1 Transmission 1 Transmission 2 Transmission 2 Service Service
NOTE: If desired, connect this network interface to a local network. This enables
you to access the Config Panel
log messages to this network.
Network: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting the computer's keyboard and mouse signals
Line In Line In Serial Serial
USB CPU: Use the USB-AM/BM-2 cable to connect one of the computer's USB inter-
faces to this interface.
VisionXS-IP
interface (for DT variants:
Network Pwr Main Power Pwr Main Power
web application from this network and to send sys-
USB CPU
DP CPU DP CPU
series can be operated with an external
Main Power ).
Red. Power
Red. Power Red. Power
G&D VisionXS-IP-C-DP-UHR · 8
Installation
).