Changing The Scancode Set Of Ps/2 Keyboards - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the PS/2
keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys do not
work as expected.
How to change the setting of the scancode set:
1. Press
Ctrl+Num
Select the row
2. Under Scancode set
 activates scancode set 2 for PS/2 keyboard inputs
2
 activates scancode set 3 for PS/2 keyboard inputs
3
3. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
(default) to open the OSD.
Console setup and press
press F8 to select one of the following options:
Enter .
G&D VisionXS-IP-C-DP-UHR · 84
Configuration