Assembling Instructions; Operation; Removing/Inserting The Battery; Recharging The Battery - Parkside PRTA 20-Li C3 Originalbetriebsanleitung

Assembling instructions

Remove the rechargeable bat-
tery from the device before
assembly. Insert the recharge-
able battery only once the de-
vice is completely assembled.
There is a risk of injury!
Mounting the distance roller:
1. Push the distance roller (15) through
the holes on the motor head (10) as far
as it will go. The distance roller (15)
points upwards.
Mounting the protective
cover:
2. Place the protective cover (12) on the
motor head (10).
3. Tighten the protective cover (12) with
the four Phillips screws (19).
Mounting the additional
handle:
4. Unscrew and remove the pre-assem-
bled handle screw (27) of the addi-
tional handle (5).
5. Slide the additional handle (5) over
the handle unit (26). The holder for the
spare spool (4) points upwards.
6. Insert the handle screw (27) through
the through hole on the handle unit
(26).
7. Screw on the auxiliary handle (5) with
the handle screw (27).

Operation

Caution: risk of injury! Do not
operate the appliance with-
out the protective cover. To
operate the appliance, wear
suitable clothing, eye and ear
protection. Prior to every use,
check that the appliance is
operative. Do not block the
On/Off switch or the switch
lock. They must reliably turn
off the motor when you re-
lease the switch. Do not op-
erate the appliance if one of
the switches is damaged.
Please observe local regulations
concerning noise protection.
Removing/inserting the
Battery
Only insert the rechargeable
battery once the battery-op-
erated tool is ready for use.
Risk of injury!
1. To remove the battery (17) from the ap-
pliance, press the release button (17a)
on the battery and pull out the battery.
2. To insert the battery (17), place it on
the guide track and push it into the ap-
pliance. It will audibly snap in.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (17) when
the red LED on the charge status
indicator (17b) is on.
1. Remove the battery (17) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (17) in the charging
compartment of the battery charger
(18).
GB
27