Assembling Instructions; Operation; Turning On And Off - Parkside PRT 550 A1 Originalbetriebsanleitung

medical implants consult their
doctor and the manufacturer
of their medical implant be-
fore operating the machine.

Assembling instructions

To put on the protective cover:
1. Place the protective cover (9)
onto the motor head (12) and fas-
ten it using the two Phillips screws
(16).
Mounting the distance
bracket (flower protection):
2. Pull the spacer apart. Insert the
two open ends of the spacer into
the lateral slots on the lower mo-
tor head (12). The spacer snaps
into two positions.
To put on the auxiliary handle:
3. Unscrew and remove the pre-
assembled screw (18) of the ad-
ditional handle (15).
4. Pull the ends of the auxiliary
handle (15) apart and slide them
over the handle unit (17).
5. Screw on the auxiliary handle
(15) with the handwheel bolt (18)
and nut (14).

Operation

Caution: risk of injury! Do not
operate the appliance with-
out the protective cover. To
operate the appliance, wear
suitable clothing, eye and ear
protection.
Prior to every use, check that
the appliance is operative. Do
not lock the On/Off button in
place. After releasing the On/
Off button, the motor must
switch off. Stop using the de-
vice if the On/Off button is
damaged.
Please observe local regulations
concerning noise protection.

Turning on and off

For transport safety during delivery,
the cutting line is knotted at the
ends. The dual line auto-feed system
regulates the cutting width during
initial start-up and the knotted ends
are automatically cut off by the line
cutter (21).
Maintain a firm stand and hold the
appliance well with both hands and at
some distance away from your body.
Before turning on the appliance, check
that it will not touch any objects.
1. Form a loop from the end of the
extension cable, pass it through
the opening on the upper handle
(1) and hook it into the strain re-
lief (4).
2. Connect the machine to the mains
voltage supply.
3. Ensure your stance is stable and
hold the appliance tightly with
both hands. Do not allow the
spool cap to hit the floor.
4. To switch the device on, press
the On/Off button (2).
To switch it off, release the
On/Off button (2).
The device cannot be switched to
continuous operation.
GB MT
63